Toshiba TD-X552M User Manual page 4

TD-X552M/TD-X552X
48) During normal use, the monitor may make occasional snapping or
popping sounds. This is normal, especially when the unit is being
turned on or off. If these sounds become frequent or continuous,
unplug the power cord and contact a Toshiba Authorized Service
Provider.
49) Handle with care when transporting. Save packaging for
transporting. Please clean the ventilation slots on the back of the
cabinet to remove dirt and dust at least once a year to maintain
reliable operation of the monitor.
50) If using the cooling fan continuously, it's recommended to clean
the ventilation slots at least once a month.
51) When installing the remote control batteries;
• Align the batteries according to the (+) and (-) indications inside
the case.
• Align the (-) indication of the batteries first inside the case.
Service
52)
WARNING:
RISK OF ELECTRIC SHOCK!
Never attempt to service the monitor yourself. Opening and
removing the covers may expose you to dangerous voltage or
other hazards. Failure to follow this WARNING may result in
death or serious injury. Refer all servicing not specified in this
manual to a Toshiba Authorized Service Provider.
53) If you have the monitor serviced:
• Ask the service technician to use only replacement parts
specified by the manufacturer.
• Upon completion of service, ask the service technician to
perform routine safety checks to determine that the monitor is in
safe operating condition.
Important Information
Canadian Department of Communications Compliance
Statement.
This product complies with any mandatory product specification in any
country/region where the product is sold. In addition, the product
complies with the following:
DOC: This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
C-UL: Bears the C-UL Mark and is in compliance with Canadian Safety
Regulations according to CAN/CSA C22.2 No. 60950-1.
FCC Declaration of Conformity Compliance Statement (Part
15):
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void your
authority to operate the equipment.
• Use the attached specified cables with the TD-X552 Series
LCD displays so as not to interfere with radio and television
reception.
1) Please use the supplied power cord to ensure FCC
compliance. If a power cord is not provided, please contact
your supplier.
2) Please use the supplied shielded video signal cable, 15-pin
mini D-SUB to 15-pin mini D-SUB.
EU conformity Statement
This product is labeled with the CE Mark in accordance
with the related European Directives, notably Low
Voltage Directive 2006/95/EC, Electromagnetic
Compatibility Directive 2004/108/EC and RoHS
Directive 2011/65/EU.
Responsible for CE-marking is TOSHIBA EUROPE
GMBH,
Hammfelddamm 8, 41460 Neuss, Germany
Warning
This is a Class A product. In a domestic environment this product may
cause radio interference, in which case the user may be required to take
adequate measures.
REACH Information
The European Union (EU) chemical regulation, REACH (Registration,
Evaluation, Authorization and Restriction of Chemicals), entered into
force on 1 June 2007, with phased deadlines to 2018. Toshiba will meet
all REACH requirements and is committed to provide our customers
with information about the presence in our articles of substances
included on the candidate list according to REACH regulation. Please
consult the following website www.toshiba.eu/reach for information
about the presence in our articles of substances included on the
candidate list according to REACH in a concentration above 0.1%
weight by weight.
iv