Adjusting The Volume Of Conversations; Changing The Ringing Tone - Panasonic Digital Cordless Telephone System Operating Instructions Manual

Press the [volume( )] key or [volume( )] key while the PS is standing by or while
it is ringing.
Pressing the [volume( )] key increases the volume, and pressing the [volume( )]
key decreases the volume.

4.2 Adjusting the volume of conversations

The volume of conversations can be adjusted in three stages (Low Middle1 Middle2 High).
Press the [volume( )] key or [volume( )] key during a conversation.
Pressing the [volume( )] key increases the volume, and pressing the [volume( )]
key decreases the volume.
4.3 Changing the Ringing Tone [Programming Required]
At default, an exchange line incoming, internal incoming and hold recall used the same ring pattern.
Although one of three ring interval can be chosen by RE programming.
(Refer programming manual page 25.)
By the combination of this ring interval specified by RE programming and Tone modulation
specified by PS programming, you can distinguish Exchange line incoming call and internal
incoming call.
At purchase, the tone on your PS is set to 16Hz.
RE Programming
Exchange line
1
incoming tone
Internal
2
incoming tone
Hold Recall Tone
3
Ring Interval
Default
0.8sec. 0.8sec.
0.2sec. 1.2sec.
Alternative
0.8sec. 0.8sec.
0.2sec. 1.2sec.
1.0sec.
2.0sec.
0.8sec. 0.8sec. 0.8sec.
0.2sec. 0.2sec. 0.2sec.
Getting Started
PS Programming
Modulated
Tone
by
16Hz
2670Hz/
24Hz
2300Hz
8Hz
9