Advertisement
Symbol Definitions
WARNINGS - Hazards or unsafe practices which could result in personal injury or product or
!
WARNING
property damage.
NOTES - contain important information and useful tips on the operation of your equipment.
Basic Tools and Materials Required
•
Four new high quality (Energizer
•
Pop rivet gun
•
Electric hand drill
•
8mm (5/16"), 10mm (3/8") and 16mm (5/8") drill bit
•
Appropriate sized drill bit for drilling rivet head on handle (if rivet IS NOT stainless steel)
•
Hand held power grinder (if rivet IS stainless steel)
•
Tape
•
Center punch
•
Adjustable open end wrench or 10mm and 13mm (11mm is also needed on roll-up door
installations) sockets/box wrenches
•
Level
•
Hacksaw
•
Hammer
•
Phillips screwdriver
•
Tape measure/Ruler
•
2mm Allen Wrench (input unit back cover)
Before Drilling
Before drilling any holes ensure that:
!
WARNING
•
You are wearing suitable eye protection.
•
Adequate protection is fitted around the surrounding area to protect such things as cables,
water/air pipes, etc., from damage.
Before starting any work, determine the position the G-152 is to be located, bearing in mind
the following points:
•
Ensure there is no obstruction on the inside of the door.
•
Ensure the vehicle is parked on flat, level ground when installing this lock.
•
Please remember you are installing a high quality, precision lock to a door which, even when
new, will have a fair amount of free play in its operation. This free play will only increase
with wear as the vehicle is used; therefore, great care must be taken during installation.
Input Unit Preparation
Remove the back of the Input Unit (4 screws) with a 2mm Allen Wrench. Place four new high quality
AA lithium batteries in the battery retainers. Reattach the back plate, ensuring that the wires are
not pinched. Once the batteries are properly installed, red LED light will flash. Connect the cable
to the lock body. Perform the Operational Check (p.7). Disconnect the cable.
2
, Duracell
, etc.) AA lithium batteries
®
®
Advertisement
