Table of Contents
Advertisement
16 Step 1: Collecting Required Tools and Supplies
Step 1: Collecting Required Tools and Supplies
•
One WLAN — Access Port (223x) per location.
•
WLAN — Access Port (223x) Mounting Kits, factory-supplied with each WLAN — Access Port (223x)
•
Optional WLAN — Access Port (223x) Ceiling-Mount Bezel kit, factory-orderable.
•
Optional external AC-to-DC power supplies, factory-orderable.
Note:
safety requirements.
•
Optional external 802.11b/g antennas.
Note:
Contact Nortel for a list of approved 802.11a and 802.11b/g external antennas.
•
Map showing WLAN — Access Port (223x) locations, with mounting and power options.
•
Screwdrivers, drill with assorted bits, and ladder. Large razor knife or keyhole saw for cutting ceiling tile.
•
An assortment of sheet metal and drywall screws and toggle bolts.
•
CAT-5 (or higher) cables to connect the WLAN — Access Port (223x) or other network device.
•
Optional Kensington MicroSaver Security Cable or wire to secure each WLAN — Access Port (223x).
Step 2: Configuring the WLAN — Access Port (223x) Before Installation on page 17
Continue with
216394-B Rev 00
This option requires the power cable to be run through the plenum in a metal conduit to meet
Nortel 2200 Series Release Notes
Refer to the
Step 1: Collecting Required Tools and Supplies
for 802.11a external antenna information.
.
Advertisement
Table of Contents
