Panasonic BT-LH1700W Operating Instructions Manual page 18

Main Menu
(continued)
SYSTEM CONFIG
Sub menu Settings
SUB WINDOW
<FULL>
<PART>
<WFM>
WFM POSITION
<LB>
<RB>
<RT>
<LT>
MENU
<CENTER>
POSITION
<LB>
<RB>
<RT>
<LT>
ROTARY
<CENTER>
POSITION
<LB>
<RB>
<RT>
<LT>
STATUS DISPLAY
<CONTINUE>
<3SEC OFF>
<OFF>
SETUP LOAD
<FACTORY>
<USER1>
<USER2>
<USER3>
<USER4>
<USER5>
SETUP SAVE
<USER1>
<USER2>
<USER3>
<USER4>
<USER5>
FAN MOTOR
<OFF>
<ON>
*1 When the monitor is shipped from the factory, "USER1" – "USER5" and "FACTORY" all have the same details.
*2 This screen is not displayed when "RGB-COMP." is selected in the "YP
menu.
g About H/V DELAY
This displays the video blanking period. By pushing the button, you can switch through the H blanking display
V blanking display
18
Explanation
Used to select the type of sub window.
<FULL>
Used to reduce the whole input signal screen, and arrange it
horizontally when it is displayed.
<PART>
Used to cut out the central section of the input signal screen, and
arrange it horizontally when it is displayed (Displayed at the same size
as the previous screen).
<WFM>
Used to display the waveform display screen.
Used to set the WFM display position.
<LB> Bottom left of the screen
<RT> Top right of the screen
Used to set the on screen menu display position.
<CENTER> Center of the screen
<LB> Bottom left of the screen
<RT> Top right of the screen
Used to set the picture adjusting knob status (on screen menu) display
position.
<CENTER> Center of the screen
<LB> Bottom left of the screen
<RT> Top right of the screen
Used to set the input signal status (on screen menu) display status.
<CONTINUE> Displayed normally.
<3SEC OFF> After changing status, it is displayed for approximately
<OFF>
The saved factory preset setting values (FACTORY) or the user data
*1
(USER 1–USER 5) are loaded. Also after loading user data, the screen
*1
displays the signal selected before loading data.
*1
*1
*1
Up to 5 sets of user data can be saved (
The menu settings and picture adjusting knob adjustment values
(PHASE /CHROMA /BRIGHT /CONTRAST) excluding "SETUP SAVE/
SETUP LOAD" are saved.
Used to set fan operation.
<OFF>
<ON>
H and V blanking display
The underlined values are factory preset setting values.
3 seconds, and then disappears.
Not displayed.
The fan is stopped. The brightness of the backlight
automatically lowers.
The fan operates. The backlight brightness returns to
normal.
P
B
no blanking display.
*2
<RB> Bottom right of the screen
<LT> Top left of the screen
<RB> Bottom right of the screen
<LT> Top left of the screen
<RB> Bottom right of the screen
<LT> Top left of the screen
page 12).
/RGB" menu in the "INPUT SELECT"
R