Start Checks; Starting - PEUGEOT Scoot'elec User Manual

Checks to be carried out each time vehicle is used : (with vehicle on its stand)
−
− Disconnect the charge lead from the 230V mains socket if necessary and put it back into its housing.
− turn the starter key into the ON position.
− check that the lights, indicators and brake lights are working.
Make sure that the energy reserve is sufficient by checking the energy gauge (J).

Starting

1. Take the vehicle off its stand and sit down on the seat.
2. Turn the starter key to ON.
The vehicle is immobilised by the anti start code, the warning lights
flash slowly (if this is not the case, see a dealer).
3. Key in your confidential code number on the key pad.
Each time a key is pressed, a bleeping sound should be heard.
Note: you should not key in the code numbers too quickly, but leave a short interval between each.
Code correct :
All warning lights come on during 1 second (except indicators)
.
Code incorrect:
try your code again after 10 seconds.
After three attempts, the vehicle is blocked. In this case, wait 15 minutes and then try your code
again.
4. The vehicle is ready to move off in handling mode.
The warning light starts to flash quickly. (If this warning light flashes slowly : the safety button is
activated: switch it to the correct position or bring the throttle grip back to zero).
5. Press the driving mode button (start) handle turns when not in motion.
The warning light
move as soon as the handle is turned.
Note :
In case of problems with the key pad, proceed as follows to key in your code.
- Press the driving mode button (START 6 page 10) as many times as the number you want to key in
(to key in the number 5, press 5 times).
- Confirm this number by putting on the rear or front brake (2 page 10).
- Key in the four figures of your code number in this way.
Note :
In case the start position is left on accidentally, the system will switch off automatically after 5 minutes. To
restart the vehicle, it is necessary to switch off and then turn back on after 2 seconds.
In the same way, if the scooter was turned ON during charging, then once the charge is over the system
cuts out completely.
In order to start, once the charger is disconnected, it is necessary to switch off and then on again after 2
seconds.
ELMANANG.DOC
comes on permanently. The vehicle is in normal speed mode and will start to
13
5/24/2003