KitchenAid KDIX 8810 Installation Instructions Manual

Hide thumbs Also See for KDIX 8810:

Advertisement

KDIX 8810
Installation instructions

Advertisement

Table of Contents
loading

Summary of Contents for KitchenAid KDIX 8810

  • Page 1 KDIX 8810 Installation instructions...
  • Page 3 Dishwasher safety Installation requirements Installation instructions...
  • Page 4: Dishwasher Safety

    Dishwasher safety Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER”...
  • Page 5: Installation Requirements

    Installation requirements Location Requirements our authorised service personnel. Please contact Protect the dishwasher and water lines leading to our Customer Care Centre. the dishwasher against freezing. Damage caused by freezing is not covered by the warranty. The dishwasher is shipped ready for installation of a one hole tap unit.
  • Page 6: Electrical Requirements

    Installation requirements Separate drain trap for the sink and dishwasher ELECTRICAL REQUIREMENTS must be provided. WARNING Dishwasher drain: Electrical Shock Hazard If the dishwasher drain exits through the back wall, Plug into a grounded 3 prong outlet. the centreline of the drain pipe must be a minimum Do not remove ground prong.
  • Page 7: Installation Instructions

    Installation instructions PREPARE DISHWASHER IMPORTANT: 1. With a utility knife, cut along the back right To prevent damage to right-hand hinge, open corner of inner carton. dishwasher lid before setting dishwasher into countertop cutout. 2. Set the dishwasher into countertop cutout. Make sure front of dishwasher is parallel to Cut along front edge of countertop.
  • Page 8: Complete Installation

    Installation instructions 1. Connect the dishwasher water fill line. 2. Connect hot and cold water lines to the tap unit. 3. Connect the sink and dishwashing drain plumbing. 4. Turn water supply on the both dishwasher and sink tap unit. Check for leaks. COMPLETE INSTALLATION WARNING Electrical Shock Hazard...
  • Page 9 Installation instructions 1. Unscrew two bolts (A) and remove GFCI cover Check operation (B) located on the front base of the dishwasher • Refer to the “Instruction For Use” booklet that inside the cabinet. came with this dishwasher and run the 2.
  • Page 12 Printed in Italy 06/08 5019 102 00395...

Table of Contents