Advertisement
2 Instructions For Use
•
Remove the Cable Tie and Plug Pin protector and unravel the cordset before
operation.
•
Place the fan on a flat level surface. (refer to "Safety Instruction" section for
Do's and Don'ts)
•
Insert the plug into a domestic power point and switch on. (230 - 240Va.c.,
50Hz)
•
Located on the back of the fan, Press the On/Off
switch to the On (I) position to start the fan.
•
Press the On/Off switch to the Off (0) position to stop
the fan.
•
To adjust the direction of the fan, hold the stand firmly
and tilt the fan grille up or down.
Caution:
Take care not to pinch yourself. Hold the stand away
from the grille when adjusting the grille angle. Always turn
the Fan OFF before adjusting the grille.
3 Care and Cleaning
•
Turn off and unplug the fan prior to cleaning.
•
Dust the grille and stand with a with a clean, damp cloth and wipe dry.
Do Not poke anything inside the grille or motor housing as this may damage the
product.
•
Never spray with liquids or submerge the Fan in water or any other liquid.
•
Do not use flammable liquids, chemicals, abrasive creams, steel wool or scouring
pads for cleaning.
4 Storage
Switch off and unplug the fan.
Coil the cable loosely. Do not kink or pull the cable tight.
Store your fan in a cool, dry location.
Read and Save These Instructions
Page 5 of 6
Advertisement
