Water Supply - Electrolux A01061301 Use And Care Manual

Water Supply

WARNING
To avoid electric shock, which can cause death or severe personal injury, disconnect
the appliance from electrical power before connecting a water supply line to the unit.
CAUTION
To Avoid Property Damage:
• Copper or Stainless Steel braided tubing is recommended for the water
supply line. Water supply tubing made of ¼ inch plastic is not recommended
to be used. Plastic tubing greatly increases the potential for water leaks, and
the manufacturer will not be responsible for any damage if plastic tubing is
used for the supply line.
• DO NOT install water supply tubing in areas where temperatures fall below
freezing.
• Chemicals from a malfunctioning softener can damage the ice maker. If the
ice maker is connected to soft water, ensure that the softener is maintained
and working properly.
IMPORTANT
Ensure that your water supply line connections comply with all local plumbing codes.
Before Installing The Water Supply Line, You Will Need:
• Basic Tools: adjustable wrench, flat-blade screwdriver, and Phillips screwdriver
• Access to a household cold water line with water pressure between 30 and 100 psi.
• A water supply line made of ¼" (6.4 mm) OD, copper or stainless steel tubing.
To determine the length of tubing needed, measure the distance from the ice
maker inlet valve at the back of the freezer to your cold water pipe. Then add
approximately 7 feet (2.1 meters), so the freezer can be moved out for cleaning (as
shown).
• A shutoff valve to connect the water supply line to your household water system.
DO NOT use a self-piercing type shutoff valve.
• A compression nut and ferrule (sleeve) for connecting a copper water supply line to
the ice maker inlet valve.
Water Supply 13