Table of Contents
Advertisement
Installing an AP
● Select an appropriate installation position and leave space above and around the device for cooling air circulation.
● Outdoors APs are used for hotspot coverage and often installed against walls or poles. The pole diameter is 30 to 114 mm.
AP6610DN dimensions (unit: mm) without a backplane support
330
● Installing the AP6610DN against a Wall:
1. Fix the wall-mounting bracket to the wall, adjust the
installation position, and use the marker, level, and
measuring tape to mark the drilling positions where
expansion bolts are installed.
3. Use four M4*14 hexagon socket head cap screws to fasten the wall-mounting bracket to the AP.
4. Pinch the wall-mounting bracket on the expansion
bolts, and fasten the Flat washer, spring washer, and
nuts in order.
Field strength
场强示意
64mm
Hexagon
socket head
cap screw
Recommended AP6610DN installation space (unit: mm)
83
2. Use #6 drill bit to drill 35–40 mm deep holes in the drilling
positions and install expansion bolts. Screw the nut into the
expansion tube, hammer the expansion bolt into a hole until
the flat washer is flattened against the wall, and remove the
nuts, spring washer, and flat washer in order.
5. Slide the AP into the wall-mounting bracket to complete
installation.
4
Flat washer
Spring washer
Nuts
Advertisement
Table of Contents
