Table of Contents
Advertisement
23
INSTALLING THE NOSE WHEEL LINKAGE
Parts Needed
Fuselage
Long threaded rod
Clevis
1.
Locate the remaining long threaded rod and clevis.
2.
Carefully cut away the covering on the bottom of the
fuselage where the pushrod will exit, if not already
done.
3.
Insert the threaded rod, threaded end first, through
the nose wheel linkage slot and into its respective
1/16 " guidance holes in the fuselage.
Tools & Adhesives Needed
Z-bend pliers
Wire cutters
Felt tipped pen
4.
Screw on a clevis 20 full turns. Fasten the clevis in the
outermost servo arm hole opposite of the rudder
servo Z-bend.
5.
Be sure that the rudder servo is centered. Using a felt
tipped pen, place a mark on the unthreaded end of
the pushrod where it passes the respective servo arm.
6.
Using Z-bend pliers, make a Z-bend at the marked
location on the rod. Cut off the excess rod.
7.
Insert the Z-bend into the hole on the servo control
arm. It may be necessary to remove the control arm
during installation of the Z-bend.
Hide quick links:
Advertisement
Table of Contents
