Table of Contents
Advertisement
22
INSTALLING THE THROTTLE LINKAGE
Parts Needed
1 Long threaded rod
1 Clevis
Fuselage
1.
Locate one of the longer threaded rods and one
clevis.
2.
Screw the clevis onto the threaded end of the rod
approximately 20 turns.
3.
Insert the threaded rod, unthreaded end first, through
the 1/16 " throttle linkage hole in the firewall. The
rod should exit through the radio tray compartment.
4.
Attach the clevis to the throttle lever of the
carburetor, opening the carburetor half way.
Tools & Adhesives Needed
Z-bend pliers
Wire cutters
Felt tipped pen
5.
Center the throttle servo. Using a felt tipped pen,
mark the rod where it passes the respective servo
arm.
Note: It is important to be sure that the carburetor
remains half open when the throttle servo is
centered.
6.
Using Z-bend pliers, make a Z-bend at the marked
spot on the rod. Cut-off the excess rod. Remove
throttle servo arm and insert Z-bend into servo arm.
Hide quick links:
Advertisement
Table of Contents
