Section 17: Installing The Engine - Hangar 9 Super Stick Instruction Manual

17
INSTALLING THE ENGINE
Parts Needed
Engine
Engine mounting bracket (2)
Engine mounting screws and nuts (4 each)
Fuselage
1.
Remove the two engine mounting brackets, four
4 x 20mm screws and four 4mm nuts from the
hardware bag.
2. Position the engine on the motor mount so the
center line of the engine is in line with the center line
of the fuselage.
3. Place one engine mounting bracket, across each of the
engine mounting lugs as shown.
Tools & Adhesives Needed
Phillips screwdriver
Blue Locktite 242
4. Insert one 4 x 20mm screw into each of the engine
mounting bracket holes. Press one of the 4mm nuts
into the corresponding receptacle on the bottom of
the motor mount. Apply Blue Locktite 242 to secure
the nut in place and firmly tighten the screw.
5. Install the fuel tube from the fuel tank pickup line to
the carburetor fuel nipple. The vent line will be
installed onto the pressure nipple after the muffler is
installed.
Hint: Do not install the muffler to the engine until
after the throttle linkage is installed.