Table of Contents
Advertisement
Electrical Connections
E
N
G
L
I
Cautions:
S
¡This product is designed to operate off a 12 volt, negative ground battery system.
H
¡To prevent damage to the unit, be sure to follow the connection diagram bellow.
37
¡Remove approx. 1/4" (5 mm) of protective covering from the ends of the leads before connecting.
¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep
cable terminals free from touching any metal parts.
¡Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when
the battery terminals are disconnected.
Supplied hardware
No.
Item
e
Power Connector
❏ Wiring Diagram
Navi Mute Lead
Connect to the Navi Mute Lead of the Panasonic
car navigation system (not available yet).
Note: Insulate the Navi Mute Lead with vinyl tape
when you do not connect it.
Antenna Control Cord
To the auto antenna control power
cord of the car
Illumination Lead
To the power line connected to
the side marker lights of the car
Dual CD Changer Control Lead (not used)
Note: Insulate the Dual CD Changer Control
Lead with vinyl tape.
External Amplifier Control Power Lead
To an external amplifier
ACC Power Lead
To ACC power, +12V DC
Battery Lead
To the car battery, continuous
+12V DC
Ground Lead
To a clean, bare metallic part of
the car chassis
Note: If your car does not have a power line connected to the side marker lights of the car, leave the illumination lead disconnected.
46
CQ-SRX7000U
Q'ty
1
NAVI MUTE
ANT-CONT MAX 0.1A
ILLUMINATION
TWIN CD·C-CONT
AMP-CONT MAX 0.1A
ACC
BATTERY 10A
(Yellow) Fuse (10A)
(Black)
SD/CD Receiver
CQ-SRX7000U
(Rear)
Antenna
(Orange)
(Blue)
(Orange / white stripe)
(Brown / white stripe)
(Blue / white stripe)
(Red)
Resistor (1kΩ)
CD Changer
Control
Connector
e Power Connector
Advertisement
Table of Contents
