Table of Contents
Advertisement
Installation Guide
E
N
G
L
I
S
H
31
This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not contain
warnings or cautions of potential dangers involved in attempting to
install this product.
Any attempt to install this product in a motor car by anyone other
than qualified installer could cause damage to the electrical system
and could result in serious personal injury or death.
❏ Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to install it. The
instructions in these pages will guide you through
the remaining steps: (Please refer to the "WARN-
ING" statement above).
¡Identify and label the car wires.
¡Connect the car wires to the wires of the power
connector.
¡Install the unit in the dashboard.
¡Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Caution: This unit operates with a 12 volt DC nega-
tive ground auto battery system only. Do not attempt
to use it in any other system. Doing so could cause
serious damage.
Before you begin installation, look for the items on
the right which are packed with your unit.
¡Warranty Card ...... Fill this out promptly.
¡Panasonic Servicenter for Service Directory
...... Keep for future reference in case the product
needs servicing.
¡Installation Hardware ...... Needed for in-dash
installation
40
CQ-SRX7000U
WARNING
❏ Installation Hardware
No.
q
Mounting Collar
w
Mounting Bolt (5 mmø)
e
Power Connector
r
Removable Face Plate Case
t
Trim Plate
y
Rear support strap
u
Tapping screw
i
Hex. Nut
❏ Required Tools
You'll need a screwdriver, a 1.5 volt AA battery, and
the following:
12 V DC
Test Bulb
Item
Diagram
Electrical
Side-Cut
Tape
Q'ty
1
1
1
1
1
1
1
1
Pliers
Advertisement
Table of Contents
