sunjoe SDJ616 Operator's Manual

sunjoe SDJ616 Operator's Manual

13-amp bladeless electric leaf mulcher + shredder
Hide thumbs Also See for SDJ616:

Advertisement

A Division of Snow Joe
, LLC
®
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Always follow these safety guidelines. Failure to do so may
result in serious bodily injury or property loss.
General Safety WARNINGS!
You and any other operator of this leaf mulcher + shredder
must read, understand, and follow these instructions in
their entirety. Failure to follow these instructions may result
in ELECTRIC SHOCK, FIRE, and/or serious PERSONAL
INJURY.
Notice the personal safety alert symbol
manual to draw your attention to a WARNING given along
with the particular operating instruction. This means that
the operation requires special ATTENTION, CAUTION, and
AWARENESS.
m
WARNING!
Wear appropriate personal hearing
protection during use. Under some conditions and duration of
use, noise from this product may contribute to hearing loss.
m
WARNING!
The rotating part can hurt you. Keep
your hands and other body parts and loose articles of clothing
away from the funnel and discharge area.
Before using the leaf mucher + shredder, familiarize yourself
with the controls, especially how to stop the unit in an
emergency. The only individuals who should use the leaf
mulcher + shredder are those who thoroughly understand
these instructions and know how to properly operate the unit.
Children should never be allowed access to the leaf mulcher +
shredder.
m
WARNING!
This electric leaf mulcher + shredder
is designed to shred leaves, thatch, grass clippings, and pine
needles. It cannot be used to shred branches, sticks, or brush.
General Safety
1. Avoid dangerous environments – Do not use the leaf
mulcher + shredder in rain or in damp or wet locations. Do
not operate the unit in gaseous or explosive atmospheres
© 2015 by Snow Joe
, LLC
®
All rights reserved. Original instructions.
13-AMP BLADELESS ELECTRIC
LEAF MULCHER + SHREDDER
Model SDJ616
m
used in this
or use the unit near flammable or combustible liquids.
Motors in these tools normally spark, and the sparks
might ignite fumes.
2. Keep children, bystanders, and pets away – All
spectators, including pets, should be kept a safe distance
away from the work area.
3. Dress properly – Do not wear loose clothing or jewelry as
such articles can become caught in moving parts. Wear
a protective covering to contain long hair. Wearing rubber
gloves and substantial non-slip footwear is recommended
when working outdoors.
4. Use safety glasses – Also use dust mask, safety
footwear, snug-fitting clothing, protective gloves, hearing,
and head protection.
5. Use the right tool – Do not use this machine for any job
except that for which it was intended.
6. Avoid accidental starting – Do not carry the leaf mulcher
+ shredder with your finger on the switch. Make sure the
switch is off before plugging in or unplugging the unit.
7. Do not abuse the cord – Never carry the leaf mulcher
+ shredder by the cord or yank the cord to disconnect it
from the receptacle. Keep the cord away from heat, oil,
and sharp edges.
8. Do not force the appliance – It will do the job better and
with less likelihood of a risk of injury if it is used at the rate
for which it was designed.
9. Do not overreach – Keep proper footing and balance at
all times.
10. Never leave a running tool unattended – Turn the
leaf mulcher + shredder off and wait until it comes to a
complete stop before leaving the work area.
11. Stay alert – Watch what you are doing. Use common
sense. Do not operate the leaf mulcher + shredder when
you are tired or under the influence of drugs, alcohol, or
other medication.
12. Disconnect the appliance – Disconnect the appliance
from the power supply when it is not in use, before
servicing it, and when changing accessories.
13. Store idle appliances indoors – When not in use, the leaf
mulcher + shredder should be stored indoors in a dry and
high or locked-up place out of the reach of children.
14. Maintain the leaf mulcher + shredder with care – Keep
the cutting line maintained at the proper length and
thickness for optimal performance and to reduce the
risk of injury. Inspect the extension cord periodically and
immediately replace it if damaged. Keep the handles dry,
clean, and free from oil and grease. Follow the additional
recommendations described in the Maintenance section
of this manual.
SAVE THESE INSTRUCTIONS
1
Form No. SJ-SDJ616-880E-MR3
OPERATOR'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SDJ616 and is the answer not in the manual?

Questions and answers

Summary of Contents for sunjoe SDJ616

  • Page 1 13-AMP BLADELESS ELECTRIC LEAF MULCHER + SHREDDER Model SDJ616 Form No. SJ-SDJ616-880E-MR3 OPERATOR’S MANUAL A Division of Snow Joe , LLC ® IMPORTANT! or use the unit near flammable or combustible liquids. Motors in these tools normally spark, and the sparks might ignite fumes.
  • Page 2: Personal Safety

    Electrical Safety 15. Check for damaged parts – Before further use of the appliance, a part that is damaged should be carefully checked to determine that it will operate properly and 1. Ground fault circuit interrupter (GFCI) protection should perform its intended function. Check for alignment of be provided on the circuit(s) or outlet(s) to be used for moving parts, binding of moving parts, breakage of parts, this electric leaf mulcher + shredder.
  • Page 3: Double-Insulated Appliances

    Double-Insulated Appliances fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a In a double-insulated appliance, two systems of insulation polarized wall outlet.
  • Page 4: Safety Symbols

    Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all safety instructions before attempting to assemble and operate the electric leaf mulcher + shredder. Symbols Descriptions Symbols Descriptions CAUTION! Remove plug from the SAFETY ALERT –...
  • Page 5 Know Your Bladeless Electric Leaf Mulcher + Shredder Read the owner’s manual and safety instructions carefully before operating the electric leaf mulcher + shredder. Compare the illustration below to the electric leaf mulcher+ shredder in order to become familiar with the location of the various controls and adjustments.
  • Page 6: Carton Contents

    Unpacking Fig. 2 Carton Contents • Funnel cover • Funnel Leg pin • Motor bracket Telescoping leg • Telescoping legs (3) • Additional cutting lines (20) 3. With your finger pressed against the leg pin, insert the leg • Manual with registration card into the hole on the motor bracket.
  • Page 7: Funnel Assembly

    Funnel Assembly Fitting the Collection Bag 1. Fit the funnel onto the motor housing, aligning the NOTE: This unit does not come with a leaf collection bag; you funnel gap with the motor bracket rib. Lock the clamps must supply your own. You may use a plastic, paper, or cloth located on the motor bracket to secure the funnel in place collection bag, depending on your preferred method of waste (Fig.
  • Page 8: Operation

    NOTE: You can remove the telescoping legs and fit the motor bracket assembly onto a leaf-bag lined trash container for Fig. 10 On/Off button easy and convenient disposal of the shredded waste. Operation Starting + Stopping CAUTION! To prevent exposure to dusty warm air, do not stand in front of the motor ventilation slots.
  • Page 9: Overload Protection

    Adjusting the Control Dial 2. Then, push the green ON button to restart the leaf mulcher + shredder (Fig. 10). The control dial regulates the particle size and speed at which Maintenance material passes through the unit. When the control dial is set in the COARSE position, material will process through the unit faster, but will yield a larger particle size than if the ATTENTION!
  • Page 10 Cutting Lines Replacement Fig. 16 The leaf mulcher + shredder has two 0.1 in. x 12.6 in. (2.5 mm x 320 mm) heavy-duty trimmer lines that are attached to the spinning head. Before any maintenance or cleaning is done on the blades, always turn the switch off and disconnect the plug from the outlet, and wait until it comes to a complete stop.
  • Page 11: Service And Support

    5. Refer to the above steps to replace another cutting line (Fig. 19). Fig. 20 Fig. 19 NOTE: There is a built-in line cutter that will cut and trim the lines slightly longer than desired. Service and Support WARNING! For optimal performance, use only replacement cutting lines designed specifically for this electric If your Sun Joe bladeless electric leaf mulcher + shredder...
  • Page 12: Optional Accessories

    Optional Accessories WARNING! ALWAYS use only authorized Snow Joe + Sun Joe replacement parts and accessories. NEVER use ® ® replacement parts or accessories that are not intended for use with this tool. Contact Snow Joe + Sun Joe if you are unsure ®...
  • Page 13 NOTES...
  • Page 14 NOTES...
  • Page 15 SNOW JOE + SUN JOE CUSTOMER PROMISE ® ® ABOVE ALL ELSE, Snow Joe + Sun Joe are dedicated to you, our customer. We strive to make your experience as pleasant ® ® as possible. Unfortunately, there are times when a product does not work or breaks under normal operating conditions. We think it’s important that you know what you can expect from us.
  • Page 16 snowjoe.com...

Table of Contents

Save PDF