Toro workman HDX-D 07368 Operator's Manual page 56

Figure 79
1. Quick coupler hose A
2. Quick coupler hose B
3. On the disabled vehicle, connect the two jumper
hoses to the hoses that were disconnected
(Figure 80). Cap the unused fittings.
Figure 80
1. Disconnected hoses
4. On the other vehicle, connect the two hoses to the
coupler still in the coupler bracket (connect the top
hose to the top coupler and the bottom hose to the
bottom coupler) (Figure 81). Cap the unused fittings.
2. Jumper hoses
1. Jumper hoses
5. Keep all bystanders away from the vehicles.
6. Start the second vehicle and move the lift lever to
the raise position which will raise the disabled box.
7. Move the hydraulic lift lever to the neutral position
and engage the lift lever lock.
8. Install the bed safety support onto the extended lift
cylinder. Refer to Using the Bed Safety Support.
Note: With both the vehicles turned off, move
the lift lever back and forth to remove the system
pressure and ease the disconnection of the quick
couplers.
9. After completing the operation, remove the jumper
hoses and connect the hydraulic hoses to both
vehicles.
Important: Check the hydraulic fluid levels, in
both vehicles, before resuming operation.
56
Figure 81