Handle Controller Frame Installation - Titan Pro- Executive Operating Instructions Manual

Massage chair
Method of usage
As figure, the pin on the arm rest respond to the box on the fix board, the steel board
respond to the groove of arm rest.(figure 5)
Hold the arm rest with your hands, pin respond to box on the front part of the steel
board, and pin respond to box on the behind of the armrest,( check the connect wire
whether it is insert in to the bottom of the armrest frame, avoid to get stuck), the
whole arm rest covered on the fixed steel board. (figure 6)
( Figure 6)
( Figure 5)
Arm rest covered on the fixed steel board, then press the armrest make sure the pin
into the box on the fixed steel board, and pull it with your hand to check it is fasten
tightly.(figure 7)
Find out the install hole on the front part of the fixed steel board, screw the screws
with hex wrench. Figure 8
Find out the install hole on the behind part of the fixed steel board, screw the screws
with hex wrench, finish the installnation, the same installnation of the two armrest.
(figure 9)
( Figure 7)
Instruction manual
Note: the connect wire must be
insert in the right place, avoid to get stuck
Seat cushion
Armrest
( Figure 8)
Calf rest
Figure: hex head screw
fixed in front part of armrest
Armrest back cover
( Figure 9)
Figure: hex head screw
fixed in behind part of armrest

Handle controller frame installation

Handle
controller tray
Screw
Frame
Handle controller
frame assembly
Ready for the handle controller tray, steel pole, take out the fixed screws on the handle
controller tray. (Figure 1)
Insert the ball joint of the steel pole to the concave spherical of the handle controller
tray.(figure 2)
( Figure 1)
Screw the screws in to the hole which got in step 1 and tighten it, take care the
direction, should be screw it from right to left. (Figure 3)
Prepare the handle controller frame assembly in step 3.(figure 4)
( Figure 3)
Massage chair
Method of usage
( Figure 2)
( Figure 4)
Instruction manual