Engine Break-In Recommendations - Dodge CHARGER 2015 Owner's Manual

Hide thumbs Also See for CHARGER 2015:

Table of Contents

94 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

ENGINE BREAK-IN RECOMMENDATIONS

A long break-in period is not required for the drivetrain

(engine, transmission, clutch, and rear axle) in your new

Drive moderately during the first 300 mi (500 km). After

the initial 60 mi (100 km), speeds up to 50 or 55 mph (80

or 90 km/h) are desirable.

While cruising, brief full-throttle acceleration within the

limits of local traffic laws contributes to a good break-in.

However, wide-open throttle acceleration in low gear can

be detrimental and should be avoided.

The engine oil, transmission fluid, and axle lubricant

installed at the factory is high-quality and energy-

conserving. Oil, fluid, and lubricant changes should be

consistent with anticipated climate and conditions under

which vehicle operations will occur. For the recom-

mended viscosity and quality grades, refer to "Mainte-

nance Procedures" in "Maintaining Your Vehicle."

Never use Non-Detergent Oil or Straight Mineral Oil

in the engine or damage may result.

NOTE: A new engine may consume some oil during its

first few thousand miles (kilometers) of operation. This

should be considered a normal part of the break-in and

not interpreted as an indication of difficulty. Please check

your oil level with the engine oil indicator often during

the break in period. Add oil as required.

Table of Contents