Makita LS1013 Instruction Manual page 15

1
1. Sub-fence
1. Sub-fence R
2. Screws
2 1
3
1. Vise arm
2. Vise rod
3. Screw
4. Clamp screw
5. Guide fence
001546
CAUTION:
• When performing left bevel cuts, flip the fence over to the
left position as shown in the figure. Otherwise, it will
contact the blade or a part of the tool, causing possible
serious injury to the operator.
Sub-fence R (optional accessory)
001547
1
The sub-fence R can be installed on the right side of the
guide fence. Insert the rods of the sub-fence R into the holes
in the guide fence. Tighten the screws which come with the
sub-fence R to secure the sub-fence R.
CAUTION:
2
• When performing right bevel cuts, never use the sub-
fence R. It will contact the blade or a part of the tool,
causing possible serious injury to the operator.
Vertical vise
001548
4
The vertical vise can be installed in two positions on either
the left or right side of the guide fence or the base. Insert the
vise rod into the hole in the guide fence or the base and
tighten the screw to secure the vise rod.
Position the vise arm according to the thickness and shape
5
of the workpiece and secure the vise arm by tightening the
screw. If the screw to secure the vise arm contacts the guide
fence, install the screw on the opposite side of vise arm.
Make sure that no part of the tool contacts the vise when
lowering the handle fully and pulling or pushing the carriage
all the way. If some part contacts the vise, re-position the
vise.
Press the workpiece flat against the guide fence and the turn
base. Position the workpiece at the desired cutting position
and secure it firmly by tightening the vise knob.
CAUTION:
• The workpiece must be secured firmly against the turn
base and guide fence with the vise during all operations.
15