Table of Contents
Advertisement
1.
Two domestic power outlets located within 1.8 M. (6') of the RGW system location. The domestic
power supply will operate the pump and the 24V DC power transformer.
2.
A (maximum 3") overflow pipe connected to the sewer system with an approved backwater
valve. A bypass line and vent pipe must be connected to the overflow pipe. The vent and over-
flow pipes must be at least the same size as the grey water inlet pipe (maximum 3")
3.
A (maximum 3") grey water inlet pipe from grey water supplying fixtures.
4.
A fresh water make-up supply connection complete with an approved cross connection control
device (if required by local codes) and freshwater bypass line.
5.
A grey water supply connection to toilets.
6.
A 1" clean out drain valve (supplied) connect to the sewer line (if required by local codes) or
drains into an open trapped floor drain. It must be installed prior to system installation.
7.
The RGW system must be installed indoors on a dry, solid and level surface, protected from
damp, rain and freezing.
The RGW system is accompanied by an installation kit comprising one each of the following:
1.
Warning tape.
2.
1" Clean out drain ball valve.
3.
Ø1" Yellow gasket and three Phillips screws.
4.
AC Power cord.
5.
24V DC Power transformer.
6.
Spare filter.
7.
Suction foot valve unit.
8.
Water level sensor unit.
1
4
Page 8
5.0 Requirements
6.0 Installation Kit
2
6
Items shown are subject to change without notice.
UG_RGW_v1.12_EN
3
5
Advertisement
Table of Contents
