LG WT4801CW Service Manual page 20

Pipe
Pipe
Inner Tub Cap
Inlet Valve
ASM
Connector
Hose
Pressure
Tub Cover
2) Disassembly of Power Cord, Inlet
Valve ASM, D.T Housing ASM and
Pressure Switch.
① Disassemble back panel.
② Disconnect three connectors ans disassemble the
power cord.
③ Remove two pipe fixing screws and three inlet valve
screws.
④ Disconnect the leads from the inlet valve.
⑤ Separate the pipe and the connector hose from the inlet
valve.
⑥ Remove the inlet Valve.
⑦ Disconnect the leads & pressure tube from the BP
sensor.
3) Disassembly of Lid Assembly, Top
Cover, Tub Cover, Pulsator & Inner Tub
① Remove three lid fixing screws.
② Disassemble the Lid Assembly in arrow direction.
③ Remove two top cover fixig screws in the rear then
disassemble the top cover.
④ Remove the tub cover fixing screws then disassemble
tub cover.
⑤ Remove the pulsator fixing screws then disassemble
the pulsator.
⑥ Remove the hub fixing nut by a special tool.
⑦ Disassemble the inner tub.
Shaft
Rotor Nut
Hub fixing nut
20
Inner Tub Cap
Hub Fixing Nut
Out Tub
Inner Tub
Bearing Housing ASM
Rotor
Stator