Stopping The Machine; Using The Rotation Indicator - Toro GrandStand 74574 Operator's Manual

Driving Backward
1. Move the right side motion-control lever to the center,
unlocked position.
2. Slowly pull the motion-control levers rearward
23).
Figure 22
Figure 23

Stopping the Machine

To stop the machine, move the motion-control levers to
neutral, move the right side motion-control lever into the
neutral-lock position, disengage the power-take off (PTO),
and turn the ignition key to the Off position.
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake (page
the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Using the Rotation Indicator

The slots in the top of the belt covers allow the operator to
verify if the blades have stopped rotating after disengaging the
power take-off (PTO) switch.
Disengage the power take-off (PTO) switch, stop the engine,
remove the key, and wait for all moving parts to stop before
leaving the operating position.
(Figure
1
1. Rotation Indicator—slots
in the top of the belt cover
23
16). Remember to remove
1
Figure 24
52-inch mower deck shown
2. Side-discharge chute
1 2
G017978