Radio - Panasonic CQ-RG133W Operating Instructions Manual

Radio

E
N
G
L
I
S
q
Change to the Radio mode
H
Press [PWR] to change to the radio mode.
4
CPlease press [u] (eject) to eject the tape when cassette tape play mode starts.
CQ-RG133W
APM
MUTE 1
w
Band
Press [BAND] to change the band.
e
Manual Tuning
[l l TUNE]: Higher frequency
[k k TUNE]: Lower frequency
Seek Tuning
Press and hold for more than 0.5 second.
[l l TUNE]: Higher frequency
[k k TUNE]: Lower frequency
Tuning will automatically stop when the signals
of the next broadcast station are received.
r
Mono Selection
Press [MONO] for monaural reception in case a lot
of interference is present in an FM stereo signal or
to improve the listening quality of weak FM
broadcasts.
Press [MONO] again to cancel.
MONO indicator
8
CQ-RG133W
FM stereo indicator
TUNE TUNE
TRACK TRACK
DISC SCAN REPEAT RANDOM
2 4 5 6
3 MONO MONO
Preset Station Setting
Up to 6 stations can be saved in each of the FM1, FM2,
FM3 and AM preset station memories.
Note: Existing saved stations are overwritten with new
stations after following this procedure.
q
Band
Press [BAND] to select a desired band.
( page 8)
CQ-RG133W
APM
DISC SCAN REPEAT
MUTE 1 1 2 2 3 3
Preset buttons from [1] to [6]
w
Auto Preset Memory (APM)
Press and hold [BAND] (APM: auto preset memory) for more
than 2 seconds.
• The 6 stations with good reception will be automatically
sared in the memory under preset buttons.
• Once set, the preset stations are sequentially scanned for 5
seconds each.
Manual Preset Memory
q Use manual or seek tuning to find a station. ( page 8)
w Press and hold one of the preset buttons from [1] to [6]
until the display blinks once.
Preset Station Calling
Press the corresponding preset button from [1]
to [6] to tune in a preset station.
Display Change
Press [DISP] (display) to switch to the clock display.
Frequency Clock display
TUNE
TRACK
RANDOM
4 4 5 5 6 6 MONO
blinks once
Caution: To ensure safety, never attempt to preset stations
while you are driving.
CQ-RG133W
E E
N N
G G
L L
I I
S S
H H
5
9