Installation - Panasonic CQ-RG133W Operating Instructions Manual

Installation

E
N
G
L
I
S
Preparation
H
10
• Before installation, check the radio operation with
antenna and speakers.
• Disconnect the cable from the negative (–) battery
terminal (see caution below).
• Unit should be installed in a horizontal position with
the front end up at a convenient angle, but not more
than 30°.
30˚ or less
Caution: Do not disconnect the battery terminals of
a car with trip or navigational computer since all
user settings stored in memory will be lost.
Instead take extra care with installing the unit to
prevent shorts.
Dashboard Installation
Installation Opening
The unit can be installed
in any dashboard having
an opening as shown at
182 mm
right. The dashboard
should be 4.5 mm - 6 mm thick in order to be able to
support the unit.
Installation Precautions
This product should be installed by a professional
installer, if possible.
In case of difficulty, please consult your nearest
authorized Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC
battery system (car) with negative ground.
2. Follow the electrical connections carefully
18). Failure to do so may result in damage to the
unit.
3. Connect the power lead (red) after all other
connections are made.
4. Be sure to connect the battery lead (yellow) to the
positive terminal (+) of the battery or fuse block
(BAT) terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation
instructions of the respective equipment before
connecting it to this unit.
14
CQ-RG133W
Installation Hardware
No. Item
q
Mounting collar
w
Hex. nut (5 mmø)
e
Rear support strap
Tapping screw
r
(5 mmø 16 mm)
t Mounting bolt (5 mmø)
y
Power connector
u Dismounting plate
i
Trim plate
53 mm
(a) Using the Rear Support Strap
(a page
(b) Using the Rubber Cushion (option)
Cautions:
• We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
Diagram Q'ty
• When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and
fingers.
1
First complete the electrical connections, and
then check them for
1
The included Mounting Collar
q is designed specially for this
1
unit. Do not use it to attach any
other model.
1
1
1
2
1
y Power Connector
Engage the Mounting
Springs (C) in the
mounting holes of the
Mounting Collar q
firmly.
Mounting Spring
Insert Mounting Collar q into the
1
correctness.(a page 18)
dashboard, and bend the mounting
tabs out with a screwdriver.
The tabs to be bent vary depending on the car.
To securely install the unit, fully bend a
number of the tabs so that there is no rattling.
Example:
Mounting Holes
t Mounting Bolt
Establish the rear connection of the unit.
2
After fixing Mounting Bolt t and Power Connector
y, fix the rear of the unit to the car body by either
Mounting Springs (C)
method (a) or (b) shown on the previous page.
3
Insert Trim Plate i.
4
After installation reconnect the
negative (–) battery terminal.
Mounting
Hole
E
E
N
N
G
G
L
L
I
I
S
S
H
H
11
Tab
q Mounting
Collar
15
CQ-RG133W