GETTING STARTED
Watch overview
The Movado BOLD Motion has a button (1) on the left
side of the case that controls the watch functions. Press it
once to change the watch view. The views display in the
following order: analog, digital time, progress tracker
status, digital battery status, Bluetooth status. Analog
view is displayed by default, and the watch returns to
analog view after five seconds of inactivity. The crown
(2) is located on the right side of the case and is used
only to set the time.
NOTE: Do not operate the watch button or pull the crown
out while the watch is wet or underwater.
Setting the time
1. Gently pull the crown out to position 2; the seconds
hand stops moving.
2. Rotate the crown in either direction to move the hour
and minute hands to the desired time.
3. Push the crown back in to position 1; the seconds
hand restarts.
MOVADO BOLD MOTION USER GUIDE
Charging the watch
The watch contains two batteries. One battery controls
the digital functions of the watch and can be recharged.
The other battery controls the analog functions of the
watch and is not rechargeable.
Before you set up the watch, charge it for at least four
hours. When the battery that controls digital functions
is fully charged, it should last five to seven days with
minimal use.
The first time you charge the watch, it might not vibrate
or illuminate. When you connect the watch to power
after the first time, the watch vibrates twice and the lights
between 3 and 9 o'clock fully illuminate and then fade,
to show the current digital battery status. When all seven
lights illuminate again and stop pulsing, the watch is fully
charged.
Each time you need to charge your watch, disconnect
the charger from power and thoroughly wipe the charger
and watch contact pins with a soft, lint-free cloth before
connecting the charger to power and then to the watch. If
needed, you may dampen the cloth with a small amount
of isopropyl rubbing alcohol. Never use soap or any
chemicals other than isopropyl rubbing alcohol to clean
the contact pins on the watch or charger.
Make sure that the isopropyl alcohol does not come into
contact with the watch strap.
Replacement of either battery—for the analog or the
digital functions—requires service from a Movado
Authorized Service Center. For locations, visit www.
mgiservice.com/movado. Never open the watch or
attempt to replace the batteries yourself; opening the
watch case will void your warranty. Movado Group
assumes responsibility only for service performed at its
Authorized Service Centers.
1
Need help?
Do you have a question about the BOLD MOTION and is the answer not in the manual?
Questions and answers