Movado BOLD Motion Online User Manual

GETTING STARTED
Watch overview
The Movado BOLD Motion has a button (1) on the left
side of the case that controls the watch functions. Press it
once to change the watch view. The views display in
the following order: analog, progress tracker status,
digital time, digital battery status, Bluetooth status.
Analog view is displayed by default, and the watch
returns to analog view after five seconds of inactivity.
The crown (2) is located on the right side of the case
and is used only to set the time.
NOTE: Do not operate the watch button or pull the
crown out while the watch is wet or underwater.
Setting the time
1. Gently pull the crown out to position 2; the seconds
THIS FILE PREPARED BY:
MOVADO GROUP ADVERTISING DEPARTMENT
Project Name: BOLD Motion Online User Guide
Brand: MOVADO Job No.: MO-16-478
Size/Color/Screen: 4C
Trim: 8.25" x 11"
Creative Director: Richard Tassone
Copy Director: Debbie Gibson
Art Director: Carolyn Schwartz
Production Manager: Pat Carr
Supplier: Imtech
MOVADO BOLD MOTION USER GUIDE
Bleed: N/A
Live:
hand stops moving.
2. Rotate the crown in either direction to move the hour
and minute hands to the desired time.
3. Push the crown back in to position 1; the seconds
hand restarts.
Charging the watch
The watch contains two batteries. One battery controls
the digital functions of the watch and can be recharged.
The other battery controls the analog functions of the
watch and is not rechargeable.
Before you set up the watch, charge it for at least four
hours. When the battery that controls digital functions
is fully charged, it should last five to seven days with
minimal use.
The first time you charge the watch, it might not vibrate
or illuminate. When you connect the watch to power
after the first time, the watch vibrates twice and the lights
between 3 and 9 o'clock fully illuminate and then fade,
to show the current digital battery status. When all seven
lights illuminate again and stop pulsing, the watch is
fully charged.
Each time you need to charge your watch, disconnect
the charger from power and thoroughly wipe the charger
and watch contact pins with a soft, lint-free cloth before
connecting the charger to power and then to the watch.
If needed, you may dampen the cloth with a small
amount of isopropyl rubbing alcohol. Never use soap
or any chemicals other than isopropyl rubbing alcohol to
clean the contact pins on the watch or charger.
Make sure that the isopropyl alcohol does not come into
a
MGI APPROVAL STAMP
INITIAL DATE
E. GRINBERG:
MARY LEACH:
RICH TASSONE:
ART DIRECTOR:
COPY DIRECTOR:
ACC'T MANAGER:
PRODUCTION MGR:
INITIAL DATE
BRAND PRESIDENT:
MARKETING DEPT.:
VISUAL MERCH.:
SALES DEPT.:
TECHNICAL:
TIM MICHINO:
OTHER: