Supplying The Power - Panasonic BT-LH900A Operating Instructions Manual

Supplying the power

An Anton/Bauer or V-mount type of battery pack or an external DC power supply can be used to power this monitor.
Using the Anton/Bauer type
battery pack
1
Install the Anton/Bauer type of battery pack.
2
Insert the battery pack and slide it in the direction of the
arrow.
Release lever
<Reference>
To remove the battery pack, slide it in the opposite direction
to the one in which it was attached while keeping the release
lever on the battery holder pulled down all the way.
10
Using a V-mount type battery
pack
CAUTION:
These servicing instructions are for use by qualified
Battery pack
service personel only. To reduce the risk of electric
shock, do not perform any servicing other than that
contained in the operaiting instructions unless you
are qualified to do so.
1
Remove the battery holder.
2
Install the accessory metal battery mount.
3
Fix the V-mount type battery holder with four screws
(length 8 mm) supplied with the holder, and then fasten
the two screws on the terminal section.
This connector is not used.
Battery holder
Metal battery mount
V-mount type battery holder