Sanyo VPC-C5 Service Manual page 20

7. LCD Panel Adjustment
[VF1 board (Side B)]
7-1. LCD RGB Offset Adjustment
Preparation:
POWER switch: ON
Adjusting method:
1. Double-click on the DscCalDi.exe.
2. Adjust LCD "RGB Even" so that the amplitude of the CL423
waveform is 1.0 V ± 0.05 V.
3. Adjust LCD "RGB Odd" so that the amplitude of the CL423
waveform is 4.5 V ± 0.05 V.
1.0 ± 0.05 V
CL423 waveform
7-2. LCD Gain Adjustment
Adjusting method:
1. Adjust LCD "RGB Gain" so that the amplitude of the CL423
waveform is 1.55 V ± 0.05 Vp-p.
Note:
7-1. LCD RGB Offset adjustment should always be carried
out first.
CL423 waveform
CL423
4.5 ±
0.05 V
0 V (GND)
1.55 V
± 0.05 Vp-p
3-7. Factory Code Setting
1. Check the "Factory Code" display within the Setting group.
2. For U.S.A., Canada and NTSC general area
If "FC_SANYO_U" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_U".
3. For Europe and PAL general area
If "FC_SANYO_EX" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_EX".
3-8. Language Setting
1. Click on the " " mark located on the right of the
"Language" display BOX.
2. Select language. (Default is English.)
3. End "DscCal" and remove the camera before turning the
camera power OFF.
Calibration Upload
AWB
Firmware
Focus
Data
UV Matrix
Cal Mode
Initialize
OK
VCO
EVF
Cal Data
LCD Type
OK
USB storage
Get VID
PID
Set
Backrush pulse :
Get
– 20 –
LCD
RGB Odd
RGB Even
VCOMPP(LOW)
RGB Gain VCOMDC
Tint Phase
H AFC Test
Language
Set Serial Set
Video Mode
Set Rev.
Set
Factory Code
Set
" mark
" mark
VCOMPP(HI)
Hall Cal.
Setting