Tilt Up And Down - TOHATSU MD 30B2 Product Manual

58
ENGINE OPERATION
Trim angle adjustment (Manual tilt
type)
The transom angle adjustment
1. Stop the engine.
2. Shift into neutral.
3. Raise the outboard motor to the tilt up
position.
4. Change the thrust rod position as fol-
lowing picture.
2
7
1. Push in
2. Rise the stopper
3. Pull out
5. Reinstall the thurst rod securely.
6. Gentry lower the outboard.
Trim angle adjustment (Power tilt type)
The transom angle adjustment
1. Stop the engine
2. Operate the Power Tilt switch and
raise the outboard motor to the tilt up
position.
3. Lock the tilt with the Tilt stopper.
1
3
ENOF01238-0
4. Change the trim lock pin position as
following picture.
1. Snap pin
2. Thrust rod
5. Reinstall the thurst rod securely.
6. Operate the Power Tilt switch and
lower the outboard.
ENOM00060-A

9. Tilt up and down

ENOW00055-0
WARNING
Do not tilt up or down outboard motor
when swimmer(s) or passenger is near to
prevent them from being caught between
outboard motor body and clamp bracket in
case the outboard motor body falls.
ENOW00048-0
WARNING
When tilting up or down, be careful not to
p l a c e y o u r h a n d b e t w e e n t h e s w i v e l
bracket and the stern bracket.
Be sure to tilt the outboard motor down
slowly.
2
1
ENOF01147-0