Warming Up The Engine - TOHATSU MD 30B2 Product Manual

50
ENGINE OPERATION
4. Tie a loop in the another end of the
emergency starter rope and attach
socket wrench that is included in the
tool kit.
ENOW00860-0
Be sure to keep the harness away from the
7
rotation parts.
5. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
6. Set the control lever in the Neutral
position.
7. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
8. After engine starts, do not reinstall fly-
wheel cover and top cowl.
ENOF00663-0
CAUTION
ENOM00043-A

4. Warming up the engine

ENOW00932-0
CAUTION
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
about
3 minutes : above 41°F (5
5 minutes at 2000 rpm : above 41°F (5
This allows the lubricating oil to circulate to
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
1
1. Idle port
2. Cooling water check port 30, 40, 50
1
1. Idle port
2. Cooling water check port 75, 90, 115
)
)
2
ENOF00664-0
2
ENOF00665-0