Clock Display At Power Off - Panasonic CQ-C1301U Operating Instructions Manual

Preparation
1
Set your car's ignition switch to the ACC or
ON position.
The demonstration screen appears.
A C C
Pull the insulation film out from the
backside of the remote control
nly
gently.
The 12-hour system is used for the clock.
1
Press [DISP] (CLOCK).
2
Hold down [DISP] (CLOCK) for more than 2
seconds.
3
Adjust the hour.
[ ]: sets the hour ahead.
[ ]: sets the hour back.
4
Press [DISP] (CLOCK).
5
Adjust the minute.
[ ]: sets the minute ahead.
[ ]: sets the minute back.
6
Press [DISP] (CLOCK).
Notes:
"ADJUST" is displayed before adjusting the clock.
Hold down [ ]
O N
(clock display)
Hours blinks
Hours set
Minutes blinks
Minutes set
Complete
or [ ] to change numbers rapidly.
2
Press [DISP] (Display).
The demonstration screen is canceled, and no more
appears.
3
Press [SRC] (PWR: Power).
Note: If you would like to turn on the power and make the
demonstration message appear, hold down [SRC] (PWR)
for more than 4 seconds.
Note: Battery Information:
Battery Type: Panasonic lithium battery (CR2025) (Included in
the remote control)
Battery Life: Approximately 6 months under normal use (at
room temperature)

Clock Display at Power Off

Press [DISP] to change the display.
Display off
Clock display