Woods DS8.50 Operator's Manual page 36

Crossbar Timing
Crossbar must be re-timed anytime a crossbar or a
side drive is disconnected.
1. To re-time crossbars, position bars as shown in
Figure 21.
UNIVERSAL JOINT REPAIR
1. Yoke
2. Cup and bearing
3. Snap ring
4. Journal cross
Figure 22. Universal Joint Exploded View
U-Joint Disassembly
1. Remove external snap rings from yokes in four
locations as shown in Figure 22.
36 Dealer Service
Figure 21. Crossbar Timing - Bottom View
2. The right crossbar will be at right angles to the front
of the cutter.
3. Measure from the front of the cutter to the blade pin
on left crossbar.
4. Hold crossbars in position while connecting the
side drivelines.
Figure 23. Remove Snap Ring
MAN1168 (5/27/2016)