Port, Application, And Extension Blade Power Led Description; Port Blade Status Led Description; Fc Ports Status Led Description - Brocade Communications Systems DCX 8510-8 Hardware Installation Manual

Determining the status of a port, application, or extension blade

Port, application, and extension blade power LED description

The following table describes the port, application, and extension blade power LED patterns and the recommended actions for those
patterns.
TABLE 7 Port, application, and extension blade power LED description
LED purpose
Power LED

Port blade status LED description

The following table describes the port and application blades status LED patterns and the recommended actions for those patterns.
TABLE 8 Port and application blades status LED description
LED purpose
Status LED

FC ports status LED description

The following table describes blade FC ports status LED patterns and the recommended actions for those patterns.
TABLE 9 FC ports status LED description
LED purpose
FC Port Status
86
Color
Steady green
No light (LED is off)
Color
No light (LED is off)
Steady amber
Slow-flashing amber (on 2
seconds, then off 2 seconds)
Fast-flashing amber (on 1/2
second, then off 1/2 second)
Color
No light (LED is off)
Steady green
Slow-flashing green (on 1 second,
then off 1 second)
Status
Blade is enabled.
Blade is not powered on.
Status
Blade is either healthy or does not
have power.
Blade is faulty.
Blade is not seated correctly or is
faulty.
Environmental range exceeded.
Status
Port has no incoming power, or
there is no light or signal carrier
detected.
Polling is in progress.
Connected device is configured in
an offline state.
Port is online (connected to an
external device) but has no traffic.
Port is online but segmented,
indicating a loopback plug or cable
or an incompatible switch.
Brocade DCX 8510-8 Backbone Hardware Installation Guide
Recommended action
No action required.
Ensure that the blade is firmly
seated and either the thumbscrew
is fully engaged or the slider is
pushed up and the ejectors are fully
engaged.
Recommended action
Verify that the power LED is on.
Ensure that the blade is firmly
seated and check the status by
entering the slotShow command. If
LED remains amber, consult the
device supplier.
Pull the blade out and reseat it. If
LED continues to flash, replace the
blade.
Check for out-of-bounds
environmental condition and correct
it.
Recommended action
Verify that the power LED is on,
check the transceiver and cable.
Allow 60 seconds for polling to
complete.
Verify the status of the connected
device.
No action required.
Verify that the correct device is
attached to the chassis.
53-1002180-15