Assembly - Ryobi WS731 Operator's Manual

UNPACKING
This product requires assembly.
 Carefully lift the saw from the carton and place on a level
work surface.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
TOOLS NEEDED
See Figure 5, page 16.
The following tools (not included or drawn to scale) are
needed for alignment:
 Adjustable wrench
 13 mm wrench
 3 mm hex key
 Framing square
LOOSE PARTS LIST
See Figure 6, page 18.
Tile Cutting Wheel
Bevel Block
Rip Guide
Water Tray
Wheel Wrench
6 mm Hex Key
Large and Small Socket Head Screws
Motor Head Assembly
Water Tray Frame
Pan Flow Control Valve
Operator's Manual (Not Shown)
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.

ASSEMBLY

WARNING:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental start-
ing and possible serious personal injury.
INSTALLING MOTOR HEAD ASSEMBLY TO
FRAME
See Figure 7, page 18.
 Align the holes in the motor head assembly with the holes
on the side of the water tray frame.
 Insert large and small socket head screws and finger
tighten.
 Using the
head screws on the side of the water tray frame.
 Tighten the small socket head screws last.
INSTALLING PAN FLOW CONTROL VALVE TO
THE WATER TRAY
See Figure 8, page 18.
 Unscrew the pan flow control valve cap.
 Place the pan flow control valve into the hole in the water
tray as shown. Set the valve lip on the tray ledge so that
the rib of the valve fits into the notch on the tray.
 Reinstall the cap onto the threaded end of the valve and
tighten securely.
INSTALLING TILE SAW TO THE WATER TRAY
See Figure 8, page 18.
 Carefully place the water tray frame inside the water tray.
Saw head assembly goes to the back of the frame where
the hose connections are located.
INSTALLING CLEAR HOSE TO WATER
CONNECTION
See Figure 9, page 19.
 Attach the clear hose into the pan flow control valve con-
nection on the inside of the water tray. Make sure there
are no kinks in the hose.
8 — English
6 mm hex key, securely tighten the large socket