Specific Safety Rules - Ryobi WS731 Operator's Manual

 ALWAYS SECURE WORK firmly against the rip guide or
bevel block.
 NEVER stand or have any part of your body in line with
the path of the wheel.
 NEVER attempt to free a stalled wheel without first turning
the saw OFF and disconnecting the saw from the power
source.
 IF THE POWER SUPPLY CORD IS DAMAGED, it must
be replaced only by the manufacturer or by an authorized
service center to avoid risk.
 AVOID AWKWARD OPERATIONS AND HAND
POSITIONS where a sudden slip could cause your hand
to move into the cutting tool.
 MAKE SURE THE WORK AREA HAS AMPLE LIGHTING
to see the work and that no obstructions will interfere with
safe operation BEFORE performing any work using the
saw.
 ALWAYS TURN OFF SAW before disconnecting it, to
avoid accidental starting when reconnecting to power
supply.
CALIFORNIA PROPOSITION 65
WARNING:
This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may
contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive
harm. Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products and,
• arsenic and chromium from chemically treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your
exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially
designed to filter out microscopic particles.

SPECIFIC SAFETY RULES

4 — English
 THIS TOOL should have the following markings:
a) To reduce the risk of injury, the user must read and
understand operator's manual.
b) Wear eye, hearing, and respiratory protection when
operating the tool.
c) Do not remove the wheel guard.
d) Never operate the tool without the wheel guard se-
curely closed.
e) Turn off tool, wait for the wheel to stop moving and
disconnect the power to the tool before servicing,
when changing cutting wheels, or cleaning.
f) Never use wheels that have openings, grooves, or
teeth on this tool.
g) Always inspect and replace damaged cutting wheels
before operating the tool.
h) Do not expose to rain or other damp locations.
i) Do not fill water bath above maximum water fill line.
 SAVE THESE INSTRUCTIONS. Refer to them
frequently and use to instruct other users. If you loan
someone this tool, loan them these instructions too.