Fakir VIGOR PLUS Instruction Manual page 18

Cleaning and maintenance of the
plasma dust collector
1. Take out the plasma dust collector
and the front filter.
2. Take down the plasma dust
collector.
Warning: Please wear protective
gloves to avoid any cut on your
fingers.
3. Clean the plasma dust collector
Use mild detergent that is of neutral
acidity. Use a scouring pad or
toothbrush to clean the dust collector.
Achieve better result with warm water
(below 40 C).
0
If it is hard to eliminate all dirt, presoak
with diluted detergent and then use a
toothbrush to scrub.
• Please beware not to damage any
wiring while cleaning the dust
collector. In case if any electrical
discharge is broken, the device will
lose part of or all of its dust collection
function.
• Any broken wire should be thrown
away instead of being left inside the
unit. Otherwise, short, circuit or
high-voltage spark would be resulted.
Also, the circuit control of the device
would be affected.
• Please contact authorized Fakir
Service for electrical discharge wire.
• Please do not clean using acidic or
alkaline detergent that can create rust
on the surface of device.
18