About Recovery - Panasonic Palmcorder VDR-D50P Operating Instructions Manual

PUSH THE RESET SWITCH.
CHECK THE DISC AFTER PUSHING THE RESET SWITCH TO REPAIR THE DATA.
An irregularity in the unit has been detected. Press the RESET button to restart the unit. (l 99)
EXIT THE MENU THEN CHANGE TO MANUAL MODE.
CANCEL MAGICPIX MODE.
You are attempting to use a function that cannot be used simultaneously.
CANNOT SET.
With DVD-RW (Video format) and DVD-R/DVD-R DL discs, if the number of dates displayed when
(BY DATE) is selected is 99, you cannot change the aspect ratio from 16:9 to 4:3 and vice
versa.
DISCONNECT USB CABLE.
The unit cannot correctly establish the connection to the PC or printer. Disconnect and reconnect
the USB cable and then select the desired USB function again.
CANNOT OPERATE WHILE CONNECTED TO COMPUTER.
The unit's power cannot be turned off when the unit is connected to the PC.

About recovery

It is possible that the system cannot complete writing of a file normally when, for example, power is
turned off for some reason during recording or editing.
If faulty management information is found when a disc is accessed, the following message may appear.
Be sure to follow the messages. (Repairing may take time depending on the error.)
DISC DATA IS NOW BEING REPAIRED. DO NOT SHAKE THE UNIT.
≥ When you repair the disc, use a battery with sufficient battery power or the AC adaptor. Even if the
power is turned off without repairing the disc, you can repair the disc when you turn the power on
again.
≥ Depending on the condition of the data, it may not be possible to completely repair the data.
≥ Do not repair a disc that has been recorded on another device. This may cause the loss of data or the
disc.
93
LSQT1319