Installing The Unit - Kenwood DNX893S Quick Start Manual

Installation
Ñ Installation procedure
1) To prevent a short circuit, remove the key from the ignition
and disconnect the ¤ terminal of the battery.
2) Make the proper input and output wire connections for
each unit.
3) Connect the speaker wires of the wiring harness.
4) Connect the wiring harness wires in the following order;
ground, battery, ignition.
5) Connect the wiring harness connector to the unit.
6) Install the unit in your car.
7) Reconnect the ¤ terminal of the battery.
8) Perform the Initial Setup. See Initial settings (P.5).

Installing the unit

Ñ Non-Japanese cars (DNX893S, DNX7160BTS,
DNX693S, DNX5160BTS)
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
24
Ñ Japanese cars
7 or 8
Car Bracket
✎
NOTE
• Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (eg, the sound may
skip).
Ñ Trim plate (DNX893S, DNX7160BTS, DNX693S,
DNX5160BTS)
1) Attach accessory 9 to the unit.
⿠General Motors cars (DNX893S)
1) Cut out accessory 5 to meet the shape of the opening
of the center console.
2) Attach accessory 5 to the unit.
Cut out to meet the shape
of the opening in the
vehicle.
7 or 8
⿠Toyota/Scion cars (DNX893S)
1) Cut out accessory 5 as illustrated.
2) Fold double-sided adhesive (accessory 6) along the
slit and attach it to accessory 5 cut-out against the
center rib as illustrated. Use 2 pieces of accessory 6 for
9
1 accessory 5 cut-out.
3) Attach accessory 5 cut-out to the unit.
6
5
Cutting line
5