Setup - Network Mode - Speco D8HT User Manual

SEQUENCE
DWELL TIME
SITE
NAME
COVERT
COLOR TUNING
MAIN OUTPUT
RESOLUTION
SUB MONITOR
OUTPUT
4-6. Setup – NETWORK Mode
Select the NETWORK tab. Then, the network menu is displayed as pictured below. Navigate through the
menu items or change the settings using the mouse or the remote control.
Set the dwell time of each, single channel display in sequential display
mode (3~60seconds)
Select a channel to apply the name and covert settings change using the
mouse or the remote control.
Select a channel to apply the following settings using the mouse.
Set the channel name. Press the right square button and set the channel
name and select OK using the mouse.
The name can be made up to 36 characters.
Enable/disable display of the specified video channel in live display.
Brightness: Change the brightness value. (0~100)
Contrast: Change the contrast value(0~100)
Hue: Change the hue value(0~100)
Saturation: Change the saturation value(0~100)
Select video output resolution
Support 1920 X 1080, 1280 X 720
Select Sub Monitor Video out.
CVBS or SPOT
45