Rebooting The Devices Or Returning Them To Their Factory Default Settings; Where To Go From Here - Cisco WAP571E Quick Start Manual

Wireless-ac/n premium dual radio outdoor access point

Hide thumbs Also See for WAP571E:

Table of Contents

If the wireless access points do not receive a DHCP response (there is no

DHCP server on your network) after 60 seconds, the access points will

fallback to the following default static IP address: 192.168.1.245 and a

default mask of 255.255.255.0. To reach that IP address, be sure that your

computer is on the 192.168.1.xxx network.

Rebooting the Devices or Returning them

to their Factory Default Settings

To reboot your device:

• The Cisco WAP571 uses PoE power supply; unplug your Ethernet

connection and plug it back in.

• With the power on, press the Reset button with an opened paper clip

for less than three seconds, or until the lights go off.

–

Release the Reset button as soon as the lights go off, or you will

restore the device to factory default settings and lose your

configurations.

–

Release the Reset button when the system light turns on.

To reset the device to factory default settings:

• With the power on, press and hold the Reset button with an opened

paper clip for more than 10 seconds. The system light will go off.

Support

Cisco Support

Community

Cisco Support and

Resources

Phone Support Contacts

Cisco WAP571E Wireless Access Point

www.cisco.com/go/smallbizsupport

www.cisco.com/go/smallbizhelp

www.cisco.com/en/US/support/

tsd_cisco_small_business

_support_center_contacts.html

Table of Contents