Lighting The Appliance; Power Vent Operation - Lennox MDLX40IN-PV Care And Operation Instructions Manual

LENNOX HEARTH PRODUCTS • MONTEBELLO

Lighting the Appliance

To light electronic appliances refer to the
detailed lighting instructions found on
Page 21 of these instructions. Instructions
can also be found on the pull-out lighting
instruction labels attached to the gas
control valve.

POWER VENT OPERATION

Operating Instructions for
the Appliance
To turn ON the appliance with the receiver:
1. Manually slide the ON/REMOTE/OFF
switch to the ON position.
2. Blower should start immediately.
3. Igniter starts sparking and pilot will light.
4. Burner should light after a few seconds.
To turn ON the appliance with the
remote transmitter:
1. Manually slide the ON/REMOTE/OFF
switch to the REMOTE position, then
press the ON/OFF key on the transmitter.
2. Blower should start immediately.
3. Igniter starts sparking and pilot will light.
4. Burner should light after a few seconds.
To Turn OFF
1. Manually slide the ON/REMOTE/OFF
switch to the OFF position or press the
ON/OFF key on the transmitter.
2. Burner and pilot should turn off
immediately.
3. Blower will continue to run for about
15 seconds, then the blower will stop.
DLX POWER VENT DV GAS FIREPLACES (MDLX40/45IN-PV) • CARE AND OPERATION INSTRUCTIONS
®
11.19
(284 mm)
13.50
(343 mm)
NOTE: Dimensions Are In Inches (mm)
Top View
Figure 8: Power Vent Termination Specifications
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
13.50
(343 mm)
Top View
Top View
16.17
(411 mm)
15.92
(404 mm)
Front View
Front View
15.92
(404 mm)
11.19
(284 mm)
10.00
(254 mm)
16.17
(411 mm)
Front View
11