Bosch 700 Series Basic Instructions page 7

Hide thumbs Also See for 700 Series:

OVEN MODEL SELECTION SINGLE

This operation is normally executed at the manufacturer facilities.

If the display board has to be replaced, the oven model must be

reconfigured. There is only one single part number for the display

board then, after having replaced it, also a single oven is

configured as a double oven 30" Multifunction/Multifunction.

IMPORTANT: ALWAYS KEEP PRESSED START KEY AT

FIRST POWER-UP ON A SINGLE OVEN, UNTIL THE

CLOCK IS DISPLAYED.

Otherwise, the control will try to run the latch auto-test but,

missing one cavity, it will never be able to complete it. At first

power-up, the control realizes that one cavity is missing: the

display shows a calibration error message. Ignore it and proceed

with the...

MANUAL TEST ACCESS PROCEDURE

1. Press CANCEL key.

2. Turn the knob 4 detents CW.

3. Turn the knob 6 detents CCW.

4. Press START key.

5. The writing MANUAL TEST is displayed.

OVEN

Table of Contents