Table of Contents
Advertisement
A beeBUS CAT5 cable may exceed more than 75 meters without additional amplifiers.
Some beeLINK2 controllers requires not only a simple IR-emitter, to operate a device. If the device is not
able to power on and off via separate commands, the beeLINK controller needs to measure the power
status of the device.
This is done using special IR-emitters that either measures the status signal on a TV-scart output or the
presence of a video signal.
OneRemote 81108180 IR-emitter cable.
Measures the DC-status on a Scart TV-output.
The Humax BXR-HD receiver cannot be powered on and off using discrete codes and does not cut of video
and status signalling, when in standby.
Therefore this receiver can only be powered on and off using the
receiver is never powered off, so this is not a problem.
The correct IR-emitter for this BEE2 converter is therefore a simple type like the 81108110:
w w w . o n e r e m o t e . d k
OneRemote 31108182 IR-emitter cable.
Measures the presence of a video output signal.
o9
command. Usually the
Page 6
Advertisement
Table of Contents
