Related Manuals for OneRemote 34003109
Summary of Contents for OneRemote 34003109
-
Page 1: User Manual
OneRemote converter Type 34003109 User Manual Operate with Beolink Technisat DIGIT ISIO S Technisat DIGIT ISIO S2 Technisat Digicorder HD S3 34003109u1uk... - Page 2 Power manuel Exit Operating using Beolink1000 Special Beolink1000 operations The OneRemote converter is best operated using a Zurück remote control with coloured buttons like the Beo4, but can also be operated with a Beolink1000. The P key on the old Beolink1000 remote control from Bang &...
- Page 3 Congratulations. The EXT controller from www.oneremote.dk can fully operate your device using your Bang & Olufsen remote control terminal, via a Bang & Olufsen TV. Beo4 Beo5 or Beo6 remote controls can be used. Beolink 1000 can be used with reduced functionality.
- Page 4 With a OneRemote OneWay or TwoWay cable, the device can be placed up to 25 metres away from the TV. It could be placed in another room, under a sofa or where ever it suits, as operation is handled via the Scartcable.
- Page 5 The same goes with the other 3 coloured buttons. This way we are able to assign other functions to the coloured buttons, when they are pressed directly. In a OneRemote environment the coloured buttons is mostly assigned to these operations: Guide, EPG or similar.
-
Page 6: Menu Option
Option programming The OneRemote EXT controller can be programmed with different options, to fit different set ups. An option programming is done by pressing a series of buttons in a special scheme that does not occur during daily use. A programming must be ended within 10 seconds. - Page 7 Installation - troubleshooting The OneRemote EXT cable must be connected to the devices ’TV’ scart output socket and a scart input socket on the TV. Then the IR-emitter must be stuck in a way that it can emit IR-light in to the devices IR- receiver, that normally receives the IR-light emitted from the devices own remote control.
- Page 8 Control LED indications Continous red or green flashing. When power is applied to the EXT controller, the LED will start flashing. The flash indicates that the EXT controller has not received a command data from the TV, since power on. As soon as a command is received from the TV, the LED will stop flashing and light solid red or green.