Cleaning; Cleaning Under The Mower; Waste Disposal - Toro 74538 Operator's Manual

1. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets (Figure 92).
Remove damaged or worn grass deflector.
6 2
1
g015594
Figure 92
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place spacer and spring onto grass deflector. Place
one J end of spring behind deck edge.
Note: Make sure one J end of spring is installed
behind deck edge before installing the bolt as shown
in Figure 92.
3. Install bolt and nut. Place one J hook end of spring
around grass deflector (Figure 92).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
4
7
3
5
5. Spring installed
6. Grass Deflector
7. J hook end of spring

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the front of the machine and use jack stands to
support the mower.

Waste Disposal

Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
58