Controls System Maintenance; Adjusting The Motion-Control Levers - Toro 74523 Operator's Manual

Controls System
Maintenance
Adjusting the Motion-Control
Levers
If the motion-control levers do not align horizontally, adjust
the right side motion-control lever.
1. Disengage the PTO, move the motion-control levers to
the neutral position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Push the motion-control levers down out of the
N - position
EUTRAL LOCK
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
69).
Figure 69
1. Left motion-control lever
2. Right motion-control lever
in the Neutral-lock position
5. To adjust the motion-control levers horizontally, you
must adjust the cam.
6. Release the cushion from the rear of the machine.
7. Loosen the nut holding the cam
(Figure 69).
(Figure
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure 70).
1. Cam
8. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the cam.
Note: Moving the cam clockwise (in the vertical
position) lowers the handle; moving the cam
counterclockwise (in the vertical position) raises the
handle.
Important: Ensure that the flat portion of the
cam does not go above a vertical position (right or
left); otherwise you may damage the switch.
9. Repeat steps 3 through
lever.
46
Figure 70
2. Nut
8 for the left motion-control