Panasonic ES-RT97 Operating Instructions Manual page 16

►Cleaningtheshaver

Remove any soap or water on the shaver if it has been washed
with hand soap or any other detergent.
Note
When cleaning the shaver after cutting a large volume of beard
with the comb attachment, hair trimmings may collect in the
cleaning tray of the self‑cleaning recharger. Discard hair
trimmings from around the trimmer before attaching the shaver
to the self‑cleaning recharger.
1
1
Inserttheappliancepluginto
theself-cleaningrecharger.
2
2
Pullupthearmuntilitclicks.
3
3 Removetheprotectivecap
orcombattachmentand
thenattachtheshaver.
4
4 Pushdownthearmuntilit
clicks.
5
5
Plugintheadaptorintoahouseholdoutlet.
• Turn the shaver off before attaching.
• Check that the system outer foil is not deformed or
damaged when you are attaching the shaver.
• Put shaver into the self‑cleaning recharger with the trimmer
handle retracted. If the trimmer handle is not retracted, it
might scratch the cleaning tray.
6
6
PresstheSELECTbuttontoselectthemode.
• The "Charge" mode starts when attaching the shaver.
• Each time you press the SELECT button, the mode
changes from "AUTO"
16
2
4
3
5
1
"Charge".
• The modes start approximately 6 seconds after they are
selected.
• The mode will be aborted if the power is cut off. In this case,
perform the mode again from the beginning.
• Do not press the cleaning liquid unit removal button as the
cleaning liquid may spill causing a malfunction.
Mode
Charge
Charge
0 to 60 min
Clean/Dry
AUTO
10 min/350 min
• It is not possible to change the mode after
"AUTO" mode has started.
• Use the self‑cleaning recharger in temperatures between 5 °C
(41 °F) and 35 °C (95 °F).
The Clean or Dry function may not work out of recommended
ambient temperature range. In such a case, "AUTO" mode
cannot be selected and the STATUS lamp will glow for
approximately 5 seconds.
Timerequired(guide)
Charge
0 to 60 min