Quick Start - Panasonic HDC-SD9PC Operating Instructions Manual

Quick start

This unit will resume recording/pause mode about 0.6 seconds after the LCD monitor is reopened.
≥ When in quick start standby mode about 60% of the power used in recording pause mode is
being consumed, so the recording time will be reduced.
1
Select the menu. (l 27)
[SETUP] # [QUICK START] # [ON]
2
Close the LCD monitor while the
mode switch is set to
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3
Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause approx. 0.6 seconds
after it is turned on.
≥ Set [QUICK START] to [OFF] to cancel the
quick start mode.
≥ Quick start standby mode is canceled if
jabout 5 minutes has elapsed
jmode switch is set to
junit is turned off
≥ In the 24p digital cinema setting, the required
time for the quick start operation is slightly
longer than 0.6 seconds.
≥ In the quick start mode, it may take some time
for automatic white balance to adjust, if the
scene being recorded has a light source
different from the scene last recorded. (When
the MagicPix function is used, however, the
white balance of the scene last recorded is
retained.)
≥ In the quick start mode, the zoom
magnification becomes 1k and the picture size
may differ from what it was before quick start
standby mode.
≥ If [POWER SAVE] (l 28) is set to
[5 MINUTES] and the unit automatically goes
.
into quick start standby mode, close the LCD
monitor and then open it again.
≥ If the unit is exposed to vibration or shock, the
time for the quick start mode to start may be
slightly longer than 0.6 seconds.
39
VQT1N45