Panasonic HDC-SD9PC Operating Instructions Manual page 37

≥ When about 5 minutes have passed without any operation in recording pause, the unit automatically
turns off to prevent the battery from running down. When you want to use the unit, turn it on again.
This power save feature can also be set to [OFF]. ([POWER SAVE]: l 28)
≥ (The maximum number of recordable pictures on a single SD card)
Maximum number of recordable scenes: 3998
Maximum number of recordable scenes with different dates: 200 (l 67)
When either of them reaches to the maximum limit, more scenes cannot be recorded.
≥ When recording motion pictures, do not remove the battery or disconnect the AC adaptor. Also, do
not remove the SD card while the card access lamp lights up. If you do either of the above, the
recovery operation will begin when the SD card is next inserted or the power is turned back on.
(l 112)
∫ Screen indications in the
recording mode
R1h20m R1h20m R1h20m
When motion picture recording stops suddenly
For some SD cards, the message appears suddenly, and recording
stops.
Use a Panasonic SD card or another SD card which can be used to
record motion pictures. (l 24)
When the unit stops while a usable SD card for recording motion
pictures (l 24) is used, the data writing rate has deteriorated.
We recommend formatting the SD card being used. (l 77) When an
SD card is formatted, all the data recorded on it will be deleted so copy
valuable data to the PC prior to formatting. (l 96)
0h00m00s 0h00m00s 0h00m00s
A Recording mode
B Remaining time left for recording
(When the remaining time is less than
1 minute, [R0h00m] flashes red.)
C Recording time elapsed
Each time the unit is put into recording
pause, the counter display will be reset to
"0h00m00s".
37
VQT1N45